- Notes, cautions, and warnings
- Introduction
- Supported data protocols
- Dell EMC PowerVault MD Series storage array rules
- Default IPv4 settings for management ports on Dell EMC PowerVault MD series storage arrays
- Supported RAID controller firmware and NVSRAM
- Supported SAS host bus adapters
- Supported iSCSI software initiators
- Supported protocol offload adapters
- Fibre Channel SFP+ Transceiver support
- Supported physical disks
- Supported expansion enclosures
- Supported management software
- Supported operating systems
- Windows ODX support
- ALUA support on supported host operating systems
- Supported device mapper software
- Supported Fibre Channel host bus adapters
- Required timeout settings for Fibre Channel host bus adapters
- Supported Fibre Channel switches
- Supported Dell EMC M1000e Fibre Channel IOMs
- Tested Brocade, Cisco, and QLogic Fibre Channel routers
Dell EMC PowerVault MD32XX/36XX Series Support Matrix
Supported Dell EMC M1000e Fibre Channel IOMs
| Fibre Channels IOMs | Firmware | Description |
|---|---|---|
| M6505 | FOS 7.0.1 | Brocade 16 Gb 24-port FCs witch module |
| M5424 | FOS 6.4.1a | 24-port 8 Gb or 4 Gb FC blade switch module |
| FOS 6.4.2 | ||
| FOS 7.0.1 | ||
| M5424-N | FOS 6.4.1a | 24-port 8 Gb or 4 Gb FC SAN module |
| FOS 7.0.1 | ||
| FC8PT | 16-port 8 Gb FC pass-through module |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\