- Notes, cautions, and warnings
- Introduction
- Supported data protocols
- Dell EMC PowerVault MD Series storage array rules
- Default IPv4 settings for management ports on Dell EMC PowerVault MD series storage arrays
- Supported RAID controller firmware and NVSRAM
- Supported SAS host bus adapters
- Supported iSCSI software initiators
- Supported protocol offload adapters
- Fibre Channel SFP+ Transceiver support
- Supported physical disks
- Supported expansion enclosures
- Supported management software
- Supported operating systems
- Windows ODX support
- ALUA support on supported host operating systems
- Supported device mapper software
- Supported Fibre Channel host bus adapters
- Required timeout settings for Fibre Channel host bus adapters
- Supported Fibre Channel switches
- Supported Dell EMC M1000e Fibre Channel IOMs
- Tested Brocade, Cisco, and QLogic Fibre Channel routers
Dell EMC PowerVault MD32XX/36XX Series Support Matrix
Tested Brocade, Cisco, and QLogic Fibre Channel routers
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\