- Notes, cautions, and warnings
- Introduction
- Supported data protocols
- ME5 Series storage system rules
- Default IPv4 Settings for management ports
- Default IPv4 settings for iSCSI ports
- Supported RAID controller firmware
- Supported iSCSI software initiators
- Supported protocol offload (TOE/iSCSI) adapters
- Supported Fibre Channel and iSCSI transceivers
- Supported cables
- Supported hard drives
- Supported expansion enclosures
- Supported management software
- Supported operating systems
- Operating systems with ALUA support
- Supported device mapper software
- Supported SAS host bus adapters
- Supported Fibre Channel host bus adapters
- Supported Fibre Channel and iSCSI direct-attach configuration operating systems
- VSS hardware writer support
- Dell Storage Support Policy
Dell PowerVault ME5 Series Storage System Support Matrix
Introduction
This document provides information about supported software and hardware for Dell PowerVault ME5012, ME5024, and ME5084 storage systems, and usage considerations, recommendations, and rules.
The Support Matrix contains the latest compatibility and interoperability information. If you observe inconsistencies between this information and other documentation, consider this document superseding.
NOTE:Unless specified, all information in this document is applicable to the latest RAID controller firmware version available at
Dell support.
This document might contain third-party content that is not under the control of Dell. The language in the third-party content might be in inconsistent with the current guidelines for Dell content. Dell reserves the right to update this document after relevant third parties update the content.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\