Integrated NIC
|
Allows you to
configure the integrated network controller. The options are:
- Enable UEFI Network Stack
- Disabled
-
NOTE: You can use the Disabled
option, only if Active Management Technology (AMT) option is disabled.
- Enabled
-
Enabled w/PXE (Default)
|
Integrated NIC 2
|
Allows you to
configure the integrated network controller. The options are:
-
Enabled (Default)
- Enabled w/PXE
-
NOTE: This feature
is supported only on Tower 7910.
|
|
|
Serial Port
|
Identifies and
defines the serial port settings. You can set the serial port to:
- Disabled
-
COM1 (Default)
- COM2
- COM3
- COM4
-
NOTE: The operating
system may allocate resources even if the setting is disabled.
|
SATA Operation
|
Tower 5810 and Tower 7810
|
Allows you to
configure the internal SATA hard-drive controller. The options are:
- Disabled
- ATA
- AHCI
-
RAID On (Default)
-
NOTE: SATA is
configured to support RAID mode. No SATA operation support in Tower
7910.
|
|
|
Tower 7910
|
Allows you to configure the internal SATA hard-drive controller.
The options are:
- Disabled
- ATA
-
AHCI (Default)
-
NOTE: SATA is
configured to support RAID mode. No SATA operation support in Tower
7910.
|
|
Drives
|
Tower 5810 and Tower 7810
|
Allows you to
configure the SATA drives on board. The options are:
- HDD–0
- HDD–1
- HDD–2
- HDD–3
- ODD–0
- ODD–1
Default Setting:
All drives are enabled.
-
NOTE: If the hard
drives are connected to a RAID controller card, the hard drives will
display {none} in all the fields. The hard drives can be seen in the
RAID controller card BIOS.
|
Tower 7910
|
Default Setting:
All drives are enabled.
-
NOTE: If the hard
drives are connected to a RAID controller card, the hard drives will
display {none} in all the fields. The hard drives can be seen in the
RAID controller card BIOS.
|
SMART Reporting
|
This field controls
if the hard drive errors for the integrated drives are reported during
system startup. This technology is part of the SMART (Self Monitoring
Analysis and Reporting Technology) specification.
-
Enable SMART Reporting - This option is disabled
by default.
|
USB Configuration
|
Allows you to
enable or disable the internal USB configuration. The options are:
- Enable Boot Support
- Enable Front USB Ports
- Enable internal USB ports
- Enable rear USB Ports
|
SAS RAID Controller (Tower 7910 only)
|
Allows you to
control the operation of the integrated SAS RAID HDD controller.
-
Enabled (Default)
- Disabled.
|
|
|
HDD Fans
|
Allows you to
control the HDD fans.
Default Setting: depends on the
system configuration
|
Audio
|
Allows you enable
or disable the audio feature.
|
Memory Map IO above 4GB
|
Allows you enable
or disable Memory Map IO above 4GB.
-
Memory Map IO above 4GB - This option is disabled
by default.
|
|
|
Thunderbolt
|
Allows you to
enable or disable Thunderbolt device support capability.
- Enabled
-
Disabled (Default)
|
Miscellaneous devices
|
Allows you to
enable or disable various on board devices.
|
|
|
PCI MMIO Space Size
|
This table gives
you POST diagnostic LED pattern information.
|
|
|