CAUTION: Ensure that you back up
all the data from the system before installing or upgrading the operating system.
NOTE: The
fcoe.ko kernel module is no longer available for creating software FCoE interfaces over Ethernet adapters and drivers. RHEL 8 installation
is supported only on hardware based FCoE-enabled storage.
Select the installation destination in the
Installation
Destination
window.
Click
Add a disk in the Specialized & Network Disks section.
Click
Add FCoE SAN, and then click
Add Drive.
The
Configure FCoE Parameters window is displayed.
Select the network interface that is connected to your FCoE switch, and then click
Add FCoE Disk(s).
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\