Models
AMT, E03J, and E04J are intended for installation only in restricted
access locations as defined in cl 1.2.7.3 of IEC 60950-1:2005.
On the basis of your configuration, your enclosure either supports
up to 24 2.5-inch SAS hard
disk drives in internal drive bays. Hard disk
drives are connected to a backplane using hard disk drive carriers
and are configured as hot-swappable.
CAUTION: : Do not
turn off or reboot your enclosure while the hard disk drive is being
formatted. Doing so can cause a hard disk drive to fail.
When you format a hard disk drive, allow enough time
for the formatting to complete. High-capacity hard disk drives can
take many hours to format.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\