Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

SCv3000 and SCv3020 Storage System Owner’s Manual

PDF

Remove the Battery Backup Unit

Use this procedure to remove the battery backup unit.

Prerequisites

  • Use Dell Storage Manager to send SupportAssist information to technical support.

  • Use Dell Storage Manager to edit the Storage Center settings and set the operation mode of the Storage Center to Maintenance mode.

Steps

  1. Shut down the storage controller using Dell Storage Manager .
  2. Make sure that all cables plugged into the storage controller are labeled.
  3. Disconnect the cables from the storage controller that was shut down.
  4. Remove the storage controller from the chassis
    • CAUTION: To prevent a thermal shutdown of the storage system, the service baffle must be installed within three minutes of removing the storage controller.
  5. Install the service baffle into the empty slot in the chassis.
  6. Verify that the battery LED on the storage controller is off. It might take a few seconds for the LED to turn off.
  7. Remove the cover from the storage controller.
  8. Lift up the handle from the battery backup unit. The battery slides away from the cage connector.
    Figure 1. Remove the Battery Backup Unit Remove the battery backup unit
    1. Battery backup unit
    2. Battery cage
    3. Cage battery connector

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\