The -portnumber and -protocol options are optional. If you exclude them, the defaults are port 443 and protocol HTTPS.
NOTE: If you do not specify a password in the command line, you are prompted
for one when the command executes. For example: vicfgcfgbackup
--server 172.17.13.211 --username root –l backupdate.datvicfgcfgbackup
--server 172.17.13.211 --username root –l backupdate.dat
After a successful restore, the system reboots using the new configuration.
For complete instructions on back up and restore commands, see VMware ESXi Embedded and vCenter Server Setup Guide at vmware.com/support/pubs.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\