- Notes, cautions, and warnings
- Introduction
- Installing vSphere 5
- Downloading the ESXi installer media
- Installing, Enabling and Disabling ESXi
- USB key or SD memory card installation
- Overview – Dell NUMA Fault Resilient Memory
- Enabling Dell NUMA Fault Resilient Memory
- Overview — Dell Fault Resilient Memory
- Enabling Dell Fault Resilient Memory
- Installing ESXi on flash media
- Installing ESXi on the hard disk drive
- Enabling or Disabling flash storage device
- Configuring one-time boot to ESXi
- Configuring boot sequence to ESXi
- Downloading the patches and updates for ESXi
- Creating the vCenter Server installation media
- Installing vCenter Server
- Installing vSphere Web Client
- Installing vSphere Client
- Deploying vSphere 5
- Configuration backup and restore procedures
- Licensing information
- Troubleshooting ESXi
- ESXi installation
- Frequently Asked Questions
- What is the minimum RAM required to install VMware ESXi on Dell PowerEdge servers?
- Why are network adapters not detected during ESXi installation on PowerEdge servers?
- Why are target devices not available in the Disk Selection wizard of ESXi installer?
- Why does ESXi display the number of processors incorrectly with the Intel Xeon processors in the Dell 13th generation BIOS settings?
- Why are keyboard inputs not received by ESXi installer?
- Supported PowerEdge configurations for vSphere 5.x
- PowerEdge FC830 configuration
- PowerEdge FC630 configuration
- PowerEdge FC430 configuration
- PowerEdge M915 configuration
- PowerEdge M910 configuration
- PowerEdge M830 configuration
- PowerEdge M820 configuration
- PowerEdge M630 configuration
- PowerEdge M620 configuration
- PowerEdge M520 configuration
- PowerEdge M420 configuration
- PowerEdge R920 configuration
- PowerEdge R910 configuration
- PowerEdge R820 configuration
- PowerEdge R815 configuration
- PowerEdge R730 configuration
- PowerEdge R730xd configuration
- PowerEdge R720 configuration
- PowerEdge R720xd configuration
- PowerEdge R715 configuration
- PowerEdge R630 configuration
- PowerEdge R620 configuration
- PowerEdge R530 configuration
- PowerEdge R520 configuration
- PowerEdge R515 configuration
- PowerEdge R430 configuration
- PowerEdge R420 configuration
- PowerEdge R415 configuration
- PowerEdge R320 configuration
- PowerEdge R220 configuration
- PowerEdge R210 II configuration
- PowerEdge T630 configuration
- PowerEdge T620 Configuration
- PowerEdge T430 configuration
- PowerEdge T420 configuration
- PowerEdge T320 configuration
- PowerEdge T110 II configuration
- Getting help
VMware vSphere 5 On Dell PowerEdge Systems Deployment Guide
PowerEdge M820 configuration
NOTE: PowerEdge M820 system is a server module of the PowerEdge VRTX system.
| PowerEdge M820 | |
|---|---|
| Processor | Intel Xeon E5-4600 and Xeon E5-4600 v2 product family |
| Minimum Memory | 4 GB |
| Internal Storage | Up to four 2.5-inch SAS/SATA HDDs |
| Internal Flash Memory | Supported SD memory card |
| Internal Storage Adapter | PowerEdge RAID Controller (PERC) H710, PERC H710P, and PERC H310 |
| External Disks Storage Adapter | Not applicable |
| Fibre Channel HBA | All supported HBAs |
| Networking | Broadcom 57810S bNDC, Intel X520 bNDC, Qlogic QMD8262-k bNDC, and supported peripheral NICs |
| Remote Access | Integrated Dell Remote Access Controller (iDRAC) 7 |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\