Vostro 15 7510 Service Manual

Installing the touchpad

1. Slide the touchpad into the slot on the palm-rest and keyboard assembly.
   NOTE: Turn the computer over and open the display. Ensure that the touchpad is equally aligned along all four sides.

   
2. Replace the two (M2x1.8) screws that secure the touchpad to the palm-rest and keyboard assembly.
3. Adhere the tapes that secure the touchpad to the palm-rest and keyboard assembly.
   NOTE: Adhere the tapes back to its original position so that it runs across touchpad and palmrest.

   

4. Align the screw holes on the touchpad bracket with the screw holes on the palm-rest and keyboard assembly.
5. Replace the three (M2x1.8) and two (M2x3) screws that secure the touchpad bracket to the palm-rest and keyboard assembly.
6. Slide the touchpad cable into the connector on the touchpad and close the latch to secure the cable.
7. Adhere the tape that secures the touchpad bracket to the palm-rest and keyboard assembly.
8. Adhere the tape that secures the speaker cable to the touchpad.