- Notes, cautions, and warnings
- Introduction
- Configuring and Using TCX Flash
- Configuring and Using TCX Multi-display
- Configuring and Using TCX Multimedia
- Configuring and Using TCX Rich Sound
- Configuring
and Using TCX USB Virtualizer
- Required Settings for TCX USB Virtualizer Use with Wyse ThinOS
- Secure Device Unlocking for Non-Administrator Users
- Redirecting USB Devices to an Off State Virtual Desktop
- Allocation of 26 Drive letters per session
- Configuring
TCX USB Virtualizer Server Software
- How to read the device Hardware ID
- Configuring TCX USB Virtualizer Server Software using UI
- Configuring the WAN Acceleration for USB devices
- Configuring
TCX USB Virtualizer Server Software using Active Directory
- Machine Level Configuration
- User Level Configuration
- Prevent redirection of USB devices
- Prevent USB redirection
- Prevent USB Redirection by device hardware ID
- All Mass Storage devices Deny write access
- Mass Storage devices Deny write access by hardware ID
- All Mass Storage devices to Prohibit WAN Acceleration
- Mass Storage devices to Prohibit WAN Acceleration by hardware ID
- Wacom devices to Prohibit WAN Acceleration by hardware ID
- Configuring the TCX USB Virtualizer Client Software
- Configuring the TCX USB redirection for Smartcards
- Using TCX Monitor
- Troubleshooting
Dell Wyse TCX Suite Version 7.2— Administrator’s Guide
Stopping, Starting, and Verifying TCX Suite Services
After the installation is complete, TCX Suite Server
software is enabled by default. You can stop and start the USB Virtualizer
or TCX Multi-display Service by using the Services applet of the Windows
Administrative Tools (right-click the name of the service you want
and select Stop or Start). For information on configuring the TCX
Suite Server software, refer to:
- Configuring TCX Flash Server Software
- Configuring TCX Multi-display Server Software
- Configuring TCX Multimedia Server Software
- Configuring TCX Rich Sound Server Software
- Configuring TCX USB Virtualizer Server Software
-
NOTE:
- You can use the Services applet in the Windows Administrative Tools to view the current status of USB Virtualizer and TCX Multi-display Service.
- After modifying a server software component (for example, USB Virtualizer), be sure to restart the service of the component by using the Services applet in the Windows Administrative Tools (for example, right-click the USB Virtualizer and select Restart).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\