In Wyse Management Suite 2.0, the Enrollment Validation option is introduced where the tenant must manually approve before the device is registered to a group. When the Enrollment Validation option is enabled, the auto-discovered devices are in Pending Validation state in the Devices page. The tenant can select a single device or multiple devices in the Devices page and validate the enrollment. The devices are moved to the intended group after they are validated.
You can enable
Enrollment Validation from
Portal Admin > Other settings.
The option is enabled by default for new tenants.
You can enable or disable
Enrollment Validation on the OOBE screen.
For existing tenants, the option is disabled.
New devices that are discovered manually or automatically are moved to Enrollment pending state. The administrator can approve the device and move to a group or unregister the device.
The count of the devices that are not approved, are displayed on the
Dashboard for approval.
All unapproved devices are listed under Enrollment Validation Pending filter drop-down in
Device page > Status.
Group administrators have the permission to validate enrollment for the devices registering to that group.
Viewers do not have the permission to validate enrollment.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\