- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the solid-state drive
- Replacing the solid-state drive
- Disconnecting the wireless antenna cables
- Reconnecting the wireless antenna cables
- Removing the speakers
- Replacing the speakers
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the touchpad
- Replacing the touchpad
- Removing the display assembly
- Replacing the display assembly
- Removing the system board
- Replacing the system board
- Removing the keyboard
- Replacing the keyboard
- Removing the palm-rest assembly
- Replacing the palm-rest assembly
- System setup
- System and setup password
- Troubleshooting
- Getting help and contacting Dell
XPS 13 Convertible Service Manual
Procedure
- Remove the eight screws (M2x3) that secure the base cover to the palm-rest assembly.
- Using your fingertips, open the system badge.
- Remove the screw (M1.6x4) under the system
badge that secures the base cover to the palm-rest assembly.
- Starting from the front corner of the computer,
pry up the base cover using a plastic scribe and lift the base cover
off the palm-rest assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\