Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

Example of Viewing a Configured Route Map

The default action is permit and the default sequence number starts at 10. When you use the keyword deny in configuring a route map, routes that meet the match filters are not redistributed.

To view the configuration, use the show config command in ROUTE-MAP mode.

Dell(config-route-map)#show config
                                 !
                                 route-map dilling permit 10
                                 Dell(config-route-map)#
                              

You can create multiple instances of this route map by using the sequence number option to place the route maps in the correct order. The system processes the route maps with the lowest sequence number first. When a configured route map is applied to a command, such as redistribute, traffic passes through all instances of that route map until a match is found. The following is an example with two instances of a route map.

Dell#show route-map
                                 
                                 route-map zakho, permit, sequence 10
                                 Match clauses:
                                 Set clauses:
                                 
                                 route-map zakho, permit, sequence 20
                                 Match clauses:
                                 interface TenGigabitEthernet 0/1
                                 Set clauses:
                                 tag 35
                                 level stub-area
                                 Dell#
                              

To delete all instances of that route map, use the no route-map map-name command. To delete just one instance, add the sequence number to the command syntax.

Dell(conf)#no route-map zakho 10
                                 Dell(conf)#end
                                 Dell#show route-map
                                 route-map zakho, permit, sequence 20
                                 Match clauses:
                                 interface TenGigabitEthernet 0/1
                                 Set clauses:
                                 tag 35
                                 level stub-area
                                 Dell#
                              

The following example shows a route map with multiple instances. The show config command displays only the configuration of the current route map instance. To view all instances of a specific route map, use the show route-map command.

Dell#show route-map dilling
                                 route-map dilling, permit, sequence 10
                                 Match clauses:
                                 Set clauses:
                                 route-map dilling, permit, sequence 15
                                 Match clauses:
                                 interface Loopback 23
                                 Set clauses:
                                 tag 3444
                                 Dell#