With Lifecycle Controller, the system can be updated using the repositories accessible through FTP, a network share or on a locally attached USB drive or a DVD. Use the
Firmware Update page to:
View the current version of the installed applications and firmware.
View a list of available updates.
Select the required updates, downloads (automatic), and then apply the updates to the following components listed in the table:
NOTE:When you update the firmware on a BCM57xx and 57xxx adapters, you notice that the cards are displayed as QLogic. This is due to the acquisition of Broadcom NetXtreme II by QLogic.
The following table lists the components that support the Firmware Update feature:
NOTE:When multiple firmware updates are applied through out-of-band methods or using the Lifecycle Controller GUI, the updates are ordered in the most efficient possible manner to reduce unnecessary restarting of a system.
NOTE:Firmware update for SAS and SATA hard drives or solid-state drives is not supported from Lifecycle Controller GUI.
* Indicates that though a system restart is not required, iDRAC must be restarted to apply the updates. iDRAC communication and monitoring will temporarily be interrupted.
** The backplanes that cannot be updated are not listed.
***Applicable only for FX2 modular systems.
Les données de cette rubrique ne sont pas disponibles
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\