- Notes, cautions, and warnings
- Additional resources
- Introduction
- Fibre Channel (FC)
- Setting Up a Windows or Mac OS Host to Use LUN storage over Fibre Channel (FC)
- Setting Up a Unix Host to Use FC Storage
- iSCSI
- Setting Up a Windows or Mac OS Host to Use LUN storage over iSCSI
- Requirements for setting up a host
- Windows host — Using multi-path management software over iSCSI
- Configuring iSCSI LUNs for the host
- Windows host — Setting up for iSCSI LUNs
- Windows host — Configuring to connect to an iSCSI interface
- Configuring a Windows Server initiator to connect to a storage system iSCSI interface — multi-path configuration
- Setup optional mutual CHAP — Windows Server in multi-path configuration
- Configure MPIO to recognize iSCSI devices
- Discover the storage system iSCSI interface in an environment — Windows Server in multi-path configuration
- Review the paths to the SP
- Verify the paths MPIO will use for load balancing
- What next?
- Configuring a Windows 7 initiator to connect to a storage system iSCSI interface
- Configuring a Windows Server initiator to connect to a storage system iSCSI interface — multi-path configuration
- Windows host — Setting up to use iSCSI LUNs
- Mac OS host — Setting up for iSCSI LUNs
- iSCSI troubleshooting
- Setting Up a Unix Host to Use iSCSI Storage
- Requirements for setting up a host
- Using multi-path management software on the host
- AIX host — Setting up for iSCSI storage
- Citrix XenServer host — Setting up for iSCSI storage
- HP-UX host — Setting up for iSCSI storage
- Linux host — Setting up for iSCSI storage
- Solaris host — Setting up for iSCSI storage
- What's next?
- iSCSI session troubleshooting
- Setting Up a Windows or Mac OS Host to Use LUN storage over iSCSI
- Migrating FC or iSCSI Data
- General Tasks for Block Hosts
- Setting Up MPIO for a Windows Cluster Using a Storage System
Dell EMC Unity™ Family Configuring Hosts to Access Fibre Channel (FC) or iSCSI Storage
Register the LUNs as MPIO devices for Windows Server
About this task
Steps
-
On the host, start the MPIO Administrative Tool:
Either and select MPIO or and type mpiocpl.exe.
- In the MPIO Properties, select MPIO Devices, then Click Add to show the Add MPIO Support dialog box.
-
Fill in the
"DGC VRAID ".
NOTE:There should be 5 extra spaces after the word DGC and 11 extra spaces after the word VRAID.
- Click OK to complete the addition of MPIO device.
- Restart the host when prompted.
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\