- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the memory modules
- Replacing the memory modules
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the wireless card
- Replacing the wireless card
- Removing the rear cover
- Replacing the rear cover
- Removing the hard drive
- Replacing the hard drive
- Removing the computer base
- Replacing the computer base
- Removing the status-light board
- Replacing the status-light board
- Removing the speakers
- Replacing the speakers
- Removing the system board
- Replacing the system board
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the heat-sink assembly
- Replacing the heat-sink assembly
- Removing the power-button board
- Replacing the power-button board
- Removing the fingerprint-reader board
- Replacing the fingerprint-reader board
- Removing the touchpad
- Replacing the touchpad
- Removing the display assembly
- Replacing the display assembly
- Removing the keyboard
- Replacing the keyboard
- Removing the palm rest
- Replacing the palm rest
- Removing the display bezel
- Replacing the display bezel
- Removing the display hinges
- Replacing the display hinges
- Removing the display panel
- Replacing the display panel
- Removing the display cable
- Replacing the display cable
- Removing the camera
- Replacing the camera
- Removing the display back-cover and antenna assembly
- Replacing the display back-cover and antenna assembly
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Dell G5 15 Service Manual
Flea power release
Flea power
is the residual static electricity that remains on the computer even
after it has been powered off and the battery has been removed. The
following procedure provides the instructions on how to conduct flea
power release:
- Turn off your computer.
- Remove the base cover.
- Press and hold the power button for 15 seconds to drain the flea power.
- Replace the base cover.
- Turn on your computer.
평점(별 1~5개)을 매겨주십시오.
평점(별 1~5개)을 매겨주십시오.
평점(별 1~5개)을 매겨주십시오.
문서가 도움이 되었는지 여부를 선택하십시오.
의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.