Dell G5 15 Service Manual

Procedure

Place the computer base on a clean and flat surface.
Replace the power-adapter port.
Replace the system board.
Replace the speakers.
Replace the status-light board.
Replace the coin-cell battery
Open the display and align the palm-rest assembly on the computer base.
Press down the edges of the palm-rest assembly and snap it into place.
Close the display and turn the computer over.
Replace the four screws (M2x3) that secure the computer base to the palm-rest assembly.
Replace the 19 screws (M2.5x6) that secure the computer base to the palm-rest assembly.
Slide the keyboard cable into the connector on the system board and close the latch to secure the cable.
Adhere the tape that secures the keyboard cable to the system board.
Slide the touchpad cable into the connector on the system board and close the latch to secure the cable.
Slide the keyboard-backlight cable into the connector on the system board and close the latch to secure the cable.
Slide the power-button board cable into the connector on the system board and close the latch to secure the cable.
Adhere the display cable to the computer base and route the display cable through the routing guides on the computer base.
Connect the display cable to the system board.
Align and place the display-cable bracket on the computer base.
Replace the screw (M2x3) that secures the display-cable bracket to the computer base.
Route the antenna cables through the routing guides on the computer base.
Adhere the camera cable to the computer base.
Connect the camera cable to the system board.

환영

환영합니다.

Procedure

본 콘텐츠를 평가해주십시오.