Hopp til hovedinnhold
  • Legg inn bestillinger raskt og enkelt
  • Vis bestillinger og spor forsendelsesstatus
  • Opprett og få tilgang til en liste over produktene dine
  • Administrer Dell EMC-områder, produkter og kontakter for produktnivå ved hjelp av virksomhetsadministrering.

iDRAC 8/7 v2.30.30.30 User’s Guide

Configuring iDRAC to use SOL using RACADM

To configure IPMI Serial over LAN (SOL):
  1. Enable IPMI Serial over LAN:
    • Using config command: racadm config -g cfgIpmiSol -o cfgIpmiSolEnable 1
    • Using set command: racadm set iDRAC.IPMISol.Enable 1
  2. Update the IPMI SOL minimum privilege level:
    • Using config command: racadm config -g cfgIpmiSol o cfgIpmiSolMinPrivilege <level>
    • Using set command: racadm set iDRAC.IPMISol.MinPrivilege 1
    where <level> is 2 (User), 3 (Operator), 4 (Administrator).
    • NOTE: The IPMI SOL minimum privilege level determines the minimum privilege to activate IPMI SOL. For more information, see the IPMI 2.0 specification.
  3. Update the IPMI SOL baud rate:
    • Using config command: racadm config -g cfgIpmiSol -o cfgIpmiSolBaudRate <baud_rate>
    • Using set command: racadm set iDRAC.IPMISol.BaudRate <baud_rate>
    where <baud_rate> is 9600, 19200, 57600, or 115200 bps.
    • NOTE: To redirect the serial console over LAN, make sure that the SOL baud rate is identical to the managed system’s baud rate.
  4. Enable SOL for each user:
    • Using config command: racadm config -g cfgUserAdmin -o cfgUserAdminSolEnable -i <id> 2
    • Using set command: racadm set iDRAC.Users.<id>.SolEnable 2
    where, <id> is the user’s unique ID.
    • NOTE: To redirect the serial console over LAN, make sure that the SOL baud rate is identical to the managed system’s baud rate.

Vurder dette innholdet

Nøyaktig
Nyttig
Brukervennlig
Var denne artikkelen nyttig?
0/3000 characters
  Oppgi vurderinger (1–5 stjerner).
  Oppgi vurderinger (1–5 stjerner).
  Oppgi vurderinger (1–5 stjerner).
  Velg om artikkelen var nyttig eller ikke.
  Kommentarer kan ikke inneholde disse spesialtegnene: <>()\