- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Safety instructions
- Recommended tools
- Screw list
- Removing the base cover
- Replacing the base cover
- Removing the battery (half-length)
- Replacing the battery (half-length)
- Removing the battery (full-length)
- Replacing the battery (full-length)
- Removing the hard drive
- Replacing the hard drive
- Removing the memory modules
- Replacing the memory modules
- Removing the wireless card
- Replacing the wireless card
- Removing the solid-state drive/Intel Optane
- Replacing the solid-state drive/Intel Optane
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the touchpad
- Replacing the touchpad
- Removing the heat sink
- Replacing the heat sink
- Removing the fans
- Replacing the fans
- Removing the I/O board
- Replacing the I/O board
- Removing the speakers
- Replacing the speakers
- Removing the display assembly
- Replacing the display assembly
- Removing the display bezel
- Replacing the display bezel
- Removing the camera
- Replacing the camera
- Removing the display hinges
- Replacing the display hinges
- Removing the display panel
- Replacing the display panel
- Removing the display back-cover and antenna assembly
- Replacing the display back-cover and antenna assembly
- Removing the system board
- Replacing the system board
- Removing the power-button board
- Replacing the power-button board
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the keyboard
- Replacing the keyboard
- Removing the palm rest
- Replacing the palm rest
- Device drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
Alienware m17 Service Manual
Procedure
- Replace the fans.
- Place the heat-sink assembly on the system board and align the screw holes on the heat-sink assembly with the screw holes on the system board.
- Tighten the captive screws in the sequential order (1>2>3>4>5>6>7) to secure the heat-sink assembly to the system board.
- Replace the four screws (M2x3) that secure the heat-sink assembly to the system board.
- Connect the left fan cable to the system board.
- Connect the right fan cable to the system board.
Podaj ocenę (od 1 do 5 gwiazdek).
Podaj ocenę (od 1 do 5 gwiazdek).
Podaj ocenę (od 1 do 5 gwiazdek).
Określ, czy artykuł były przydatny, czy nie.
Komentarze nie mogą zawierać znaków specjalnych: <>()\