Gå vidare till huvudinnehållet
  • Lägg beställningar snabbt och enkelt
  • Visa beställningar och kontrollera leveransstatus
  • Skapa och kom åt en lista över dina produkter
  • Hantera dina webbplatser, produkter och kontakter på produktnivå från Dell EMC med hjälp av företagsadministration.

Dell PowerEdge R730 Owner's Manual

Opening and closing the PCIe card holder latch

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. To open the PCIe card holder latch, press the release tab.
  2. To close the PCIe card holder latch, rotate the latch clockwise until it locks.
    NOTE: Before installing a full-length PCIe card, the PCIe card holder latch must be closed. When the full-length PCIe card is installed, open the PCIe card holder latch. Before removing the full-length PCIe card, you must close the PCIe card holder latch.
    Figure 1. Opening the PCIe card holder latch
    This figure shows opening the PCIe card holder latch
    1. PCIe card holder
    2. release tab
    3. PCIe card holder latch
    Figure 2. Closing the PCIe card holder latch
    This figure shows closing the PCIe card holder latch
    1. PCIe card holder
    2. release tab
    3. PCIe card holder latch

Next steps

Follow the procedure listed in the After working inside your system section.


Betygsätt det här innehållet

Korrekt
Användbart
Lätt att förstå
Var den här artikeln till nytta?
0/3000 characters
  Ange betyg (1–5 stjärnor).
  Ange betyg (1–5 stjärnor).
  Ange betyg (1–5 stjärnor).
  Ange om artikeln var användbar eller inte.
  Kommentarer får inte innehålla följande specialtecken: <>()\