Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Alienware m17 R2 Service Manual

PDF

Installing the right I/O-board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the right I/O-board and provides a visual representation of the installation procedure.

Image: Installing the right I/O-board

Steps

  1. Using the alignment posts, place the right I/O-board in place on the palm-rest assembly.
  2. Replace the two screws (M2x3) that secure the right I/O-board to the palm-rest asssembly.
  3. Adhere the coin-cell battery onto the RTC marking on the right I/O-board.
  4. Connect the speaker cable to the connector on the right I/O-board.
  5. Using the alignment pins, connect the right I/O-board cable on the right I/O-board and the system board.
    NOTE: The I/O-board cable is polarity sensitive. To prevent damage to your computer ensure that the MB UMT end of the cable is connected to the system board.
  6. Replace the two screws (M2x3) that secure the right I/O-board cable to the right I/O-board and system board.

Next steps

  1. Install the battery.
  2. Install the 2230 solid-state drive. (if applicable)
  3. Install the 2280 solid-state drive. (if applicable)
  4. Install the base cover.
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\