- Notes, cautions, and warnings
- Dell EMC PowerEdge R640 overview
- Documentation resources
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Drives
- Backplane cover
- Inside the system
- Air shroud
- Cooling fans
- System memory
- NVDIMM-N battery
- Processors and heat sinks
- Expansion cards and expansion card risers
- M.2 SSD module
- Optional IDSDM or vFlash module
- Optional IDSDM or vFlash module
- Network daughter card
- Integrated storage controller card
- Backplane
- Cable routing
- SAS expander card
- Rear drive cage
- System battery
- USB module
- VGA module
- Optional internal USB memory key
- Optical drive (optional)
- Power supply units
- System board
- Trusted Platform Module
- Control panel
- System diagnostics
- Jumpers and connectors
- Getting help
Dell EMC PowerEdge R640 Installation and Service Manual
Installing a drive blank
Prerequisites
Follow the safety guidelines listed in Safety instructions.
If installed, remove the front bezel.
CAUTION:Mixing drive blanks from previous generations of PowerEdge
servers is not supported.
Steps
Insert the drive blank into the drive slot, and push the blank until
the release button clicks into place.Figure 1. Installing a
drive blank 
Next steps
If removed, install the front bezel.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\