Dell Chassis Management Controller Version 6.0 for PowerEdge M1000e RACADM CLI Guide

getniccfg

Description

Displays the current NIC settings.

Synopsis

racadm getniccfg [-m <module>]

Input

–m <module> must be one of the following values:

chassis : Default state if -m is not specified.
server-<n> : where n=1–16
server-<nx> : where n=1–8; x = a, b, c, d (lower case)
switch-<n> : where n=1–6

Output

The getniccfg subcommand displays an appropriate error message if the operation is not successful. Otherwise, the output is displayed in the following format:


IPv4 settings:
NIC Enabled	=1
IPv4 Enabled	=1
DHCP Enabled	=1
IP Address	=10.94.225.165
Subnet Mask	=255.255.255.128
Gateway	=10.94.225.129
IPv6 settings:
IPv6 Enabled	=1
DHCP6 Enabled	=0
IP Address 1	=2000:de11:bcd1:fc14:1234:5678:2468:abcd
Gateway	=::
Link Local Address	=fe80::f21f:afff:fed0:82d6/64
IP Address 2	=::
IP Address 3	=::
IP Address 4	=::
IP Address 5	=::
IP Address 6	=::
IP Address 7	=::
IP Address 8	=::
IP Address 9	=::
IP Address 10	=::
IP Address 11	=::
IP Address 12	=::
IP Address 13	=::
IP Address 14	=::
IP Address 15	=::
LOM Status:
NIC Selection	=dedicated
Link Detected	=Yes
Speed	=1Gb/s
Duplex Mode	=Full Duplex
Active NIC	=Dedicated
Static IPv4 settings:
Static IP Address	=192.168.0.120
Static Subnet Mask	=255.255.255.0
Static Gateway	=192.168.0.1
Static IPv6 settings:
Static IP Address 1	=2000:de11:bcd1:fc14:1234:5678:2468:abcd/64
Static Prefix Length	=64
Static Gateway	=::

NOTE IPv6 information is displayed only if IPv6 is enabled in iDRAC.

NOTE IPv6 Address 1 field indicates static IP and IPv6 Address 2 field indicates dynamic IP.

Example

Display CMC network settings
```
racadm getniccfg -m chassis
```

Welcome

Welcome to Dell

Dell Chassis Management Controller Version 6.0 for PowerEdge M1000e RACADM CLI Guide

getniccfg

Rate this content