Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R440 Installation and Service Manual

PDF

Installing the internal PERC riser

NOTE The new generation PERC 11 H750, H350, and HBA350i adapters cannot be mixed with the PERC H740P, H730P, H330, HBA330 adapters of the previous generations in one system. For more information, see Cable routing.

Prerequisites

Follow the safety guidelines listed in Safety instructions.

Steps

  1. Connect the cable to the internal PERC card.
    Figure 1. Connecting the cable to internal PERC riser
    The image shows connecting the cable to internal PERC card
  2. Holding the blue touch points, align the slot on the internal PERC riser to the guide on the system board.
  3. Insert the internal riser card’s edge connector firmly into the system board connector until the riser is fully seated.
  4. Lift the plunger to lock the riser in place.
    Figure 2. Installing internal PERC riser
    The image shows installing internal PERC riser
  5. Connect the cables to the backplane and then route the cables to the cable guiding latch to close the latch.

Next steps

  1. Install the air shroud.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\