- Notes, Cautions, and Warnings
- Working on Your Computer
- Removing and
Installing Components
- Recommended Tools
- Removing the Cover
- Installing the Cover
- Removing the Front Bezel
- Installing the Front Bezel
- Removing the Drive Cage
- Installing the Drive Cage
- Removing the Wireless Local Area Network (WLAN) Card
- Installing the WLAN Card
- Removing the Optical Drive
- Installing the Optical Drive
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Intrusion Switch
- Installing the Intrusion Switch
- Memory Module Guidelines
- Removing the Memory
- Installing the Memory
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the System Fan
- Installing the System Fan
- Removing the Speaker
- Installing the Internal Speaker
- Removing the Power Switch
- Installing the Power Switch
- Removing the Input/Output(I/O) Panel
- Installing the Input/Output(I/O) Panel
- Removing the Power Supply Unit
- Installing the Power Supply Unit
- Removing the Heat Sink
- Installing the Heat Sink
- Removing the Processor
- Installing the Processor
- Removing the System Board
- System Board Layout
- Installing the System Board
- System Setup
- Diagnostics
- Troubleshooting Your Computer
- Specifications
- Contacting Dell
Dell OptiPlex 9010/7010 Ultra Small Form Factor Owner's Manual
Installing the WLAN Card
- Align and place the connector inside the slot of the computer.
- Align the antenna puck on the connector. Tighten the screws to secure the antenna puck to the WLAN card connector.
- Thread the cable along the computer.
- Slide the WLAN card into its slot and press it downward until it is locked in place by the securing levers.
- Connect the cables to the WLAN card.
-
Install:
- drive cage
- front bezel
- cover
- Follow the procedures in After Working Inside Your Computer.
请提供评级（1-5星）。
请提供评级（1-5星）。
请提供评级（1-5星）。
请选择这篇文章是否有帮助。
注释中不得包含以下特殊字符：<>()\