OEMR XL R7625

Denne artikel indeholder oplysninger om, hvordan du kontrollerer, om et netværkskort (NIC) er kompatibelt med en PowerEdge-server.

Denne artikel indeholder oplysninger om CPU-maskinkontrolfejl og almindelige årsager samt korrekt håndtering, når der ses fejl.

Dell Micron 7450 and 7500 Non-Volatile Memory Express solid state drives may encounter drive initialization failure due to a firmware issue, resulting in the solid state drives being unrecoverable.

Unsure about the procedure to update a specific component's firmware in a PowerEdge system? Learn how to in this specific article.

R7725, R6725, R7715 og R6715 antallet af CPU-kerner genkendes ikke korrekt.

The "Predictive failure reported for disk x" error continues to be logged every 24 hours, even after the identified drive has been replaced. The issue only affects drives connected to PERC Controllers in RAID configuration.

BIOS setting for Collaborative Processor Performance Control (CPPC) will remain disabled after attempting to enable it.

Customers may notice that the rear iDRAC system ID button LED on some specific platforms becomes dim or turns off.

PowerEdge-servere går ned med fatale PCIe-fejl under opdatering af firmwaren til Kioxia CM6 NVMe-drev.

CPU er kan opfattes som varme, mens serveren er inaktiv.

The HBA355i with Seagate 8 TB SAS hard drive fails to boot to Windows Server 2022 after a cold boot.

Lifecycle Controller logger rapporter, SPDM0001 og SPDM0003 advarselsmeddelelser efter hver iDRAC-nulstilling.

USB device latency using an external USB Hub connected to the front or back USB ports on PowerEdge R7725, R6725 systems

The Dell SS540 SAS solid state drive is reported as not correctly functioning.

This article presents opportunities to understand and troubleshoot some common causes of fan noise in a PowerEdge server. It is also relevant for 100% fan speeds.

PowerEdge R760, R7615 og R7625 24 x 2,5" NVMe-switch-backplane-upstreamlink, der viser PCIe Gen4

This article describes how to view and clear the system event log (SEL) in System Setup.

This article describes how to find the iDRAC's current MAC address.

Updating 16G PowerEdge Server BIOS may result in Secure Boot database updates.

Dell solid state drive (SSD) fails after system reports low environment operating temperature.

Dell Samsung Serial Attached SCSI (SAS) PM1653 and PM1655 solid state drives may report excessive Sense Key faults 0x3, 0x11, 0x0, or 0x4, 0x29, 0x4. These faults have the potential to cause unexpected drive issues.

Dell Enterprise SAS, SATA SSD: SMART predictive failures triggered by remaining write endurance falling below the threshold

In some migration scenarios, the OpenManage Enterprise 4.0 target import operation may fail with an error 'Failed to decrypt backup archive' during migration. Use the following article to help in troubleshooting this scenario and various ways to address the failure.

Network port enumeration on Windows Server 2022 with Dell network adapters may swap port designations.

After an update to 7.00.00.00 or higher, the iDRAC9 web server may become inaccessible where the user has uploaded a custom or CA signed web certificate.

IDRAC kan ikke oprette forbindelse til en SMB-deling (Server Message Block), når den valgfrie "SMB3-delingskryptering" er aktiveret.

BIOS/CPLD or backplane firmware DUP may fail to update when attempted soon after iDRAC restart.

This article describes what can happen while collecting SupportAssist logs using iDRAC9 UI. The operation may result in an error, or incomplete logs may be collected.

This article addresses an issue in which conversion of Windows Server from an evaluation to a fully licensed edition fails. The error that is returned appears to indicate a problem with the supplied product key, but the key is known to be valid.

Firmwaren til PowerEdge-serverharddiske er en kritisk komponent i serversystemet. Regelmæssig opdatering og vedligeholdelse af denne firmware er afgørende for serverens ydeevne, sikkerhed og kompatibilitet. Firmwareopdateringer til harddiske kan ofte rette kendte hardwarefejl og -problemer, adressere identificerede sårbarheder og sikkerhedsproblemer og potentielt introducere nye funktioner, forbedringer og forbedringer.