PowerEdge RAID Controller H740P

Denne artikel indeholder en liste over PowerEdge RAID-controllere (PERC) efter seriefamilie (generation) for Dell-systemer. Der findes flere typer PERC-controllere afhængigt af interne eller eksterne storagestik, maksimal drevunderstøttelse og RAID-understøttelse.

Denne artikel viser, hvordan du føjer yderligere diske til en virtuel disk eller omkonfigurerer en virtuel disk.

Denne artikel beskriver proceduren for åbning af en serviceanmodning (SR) via Dells supportside. Få hurtig hjælp til din Dell-enhed. Slut med at vente i venteposition. Ikke mere teknisk hovedpine. Dell gør det nemt at løse problemer, planlægge reparationer eller få support – direkte fra din enhed eller vores supportwebsted.

Denne artikel forklarer, hvordan du indlæser PERC-driveren under installationen af Windows 2022. Hvis PERC-driveren ikke er indlæst, kan installationsguiden ikke finde en lagerplacering

Denne artikel indeholder instruktioner i, hvordan du tildeler en harddisk som global hot-spare på en PowerEdge RAID-controller (PERC)

Linux host reports reduced storage performance when using PERC or HBA controllers with attached SSD or NVMe devices.

Denne artikel indeholder oplysninger om forskellige batterifejlkoder, deres mulige årsager og eksempler.

Denne artikel indeholder oplysninger om, hvordan du importerer et RAID-system med fremmed konfiguration i systeminstallationsmenuen (F2).

PowerEdge R740 og R740xd, men ikke R740xd2, bruger mini-PERC-interposeren (04M4C). I R730-servere blev dette omtalt som indbygget C-stack.

When attempting to save the PowerEdge RAID Controller (PERC) controller's event logs from within the Host Integrated Interface (HII), this process may take upwards of 20 minutes to complete.

Spørgsmål om Dell PowerEdge RAID-controllerkort og drevmanipulationer besvares her med selvstudier.

Denne artikel indeholder oplysninger om, hvordan du administrerer Dell PowerEdge RAID-controlleren (PERC) ved hjælp af PERCCLI-hjælpeprogrammet.

Når kryptering er aktiveret på BOSS-N1, stopper systemet muligvis under POST med meddelelsen: "Ingen startenhed tilgængelig eller intet operativsystem registreret."

The "Predictive failure reported for disk x" error continues to be logged every 24 hours, even after the identified drive has been replaced. The issue only affects drives connected to PERC Controllers in RAID configuration.

This article describes the different type of controllers and the ways in which they should be reseated.

Denne artikel omhandler et problem med håndtering af cachehukommelse på PERC10-controllere.

Slow insertion of a SAS or SATA drive in PowerEdge 15G or 16G Servers with a PERC or HBA controller configuration causes a "No Access" bit to be set, leading to an inability to blink and unblink drives.

PowerEdge RAID-controller (PERC11, PERC10), HII-konfigurationshjælpeprogrammet (Human Interface Infrastructure) og iDRAC understøtter ikke systemudvidelse.

This article provides information about how to boot past the Driver Health Manager Screen.

Denne artikel indeholder oplysninger om, hvordan du kontrollerer egenskaber for virtuel disk i Systemopsætning til PowerEdge-server.

The message seen is "Dell PERC Controller - Bus 24 Dev 0: F/W has indicated a system reset is required. The system reboots in 5 seconds." is the interrupted cache offload print. This print is not seen in PERC9 and PERC11. Fully completing the offload on PERC 10 before powering on prevents behavioral differences between PERC 9 and 11, and avoids the additional reset print.

I denne artikel forklares det, hvordan du bruger kommandoer til at indsamle intelligente logfiler.

This article explains how to export the RAID controller log (TTYlog) directly from OpenManage Server Administrator (OMSA) using the interface or using the command lines.

This article explains how to create a Virtual Disk using the System Settings menu.

This article explains how to download, install, and use the Dell PowerEdge RAID Controller (PERC) Command-Line Interface (CLI) utility to manage your RAID controller. The utility is supported on PERC Series 8 and later family controllers on hosts running Windows, Linux, or ESXi. PERCCLI can also extract RAID controller logs which contain information that allows you or Dell Technical Support to determine the status of RAID controllers and the connected storage devices to narrow down possible sources of error.

Denne artikel indeholder oplysninger om batteriets indlæringscyklus. Den består af en controller, der udføres batterikalibrering for periodisk at bestemme batteriets tilstand. Denne handling kan ikke deaktiveres.

This article provides information about Double Faults and Punctures in a RAID array and it also advises how to fix the problem.

This article provides information about Intelligent Mirroring and Enhanced RAID 10.

This article provides information about how to delete a virtual disk using the Device Settings menu on a PowerEdge server. If your PowerEdge server is running the UEFI mode as a boot mode, the RAID BIOS is not displayed.

Få mere at vide om Dell PERC-funktioner.