Removal
System Cover
Identify the system cover highlighted in blue.
Using a flat head or a Phillips screwdriver, rotate the lock counter clockwise.
Lift the latch until the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Air shroud
Identify the air shroud highlighted in blue.
Holding the edges of the air shroud, lift the air shroud out of the system.
Drive backplane cover
Identify the drive backplane cover highlighted in blue.
Slide the drive backplane cover to the rear of the system.
Lift the drive backplane cover from the system.
Cooling fan cage assembly
Identify the cooling fan cage assembly highlighted in blue.
Rotate the blue release levers to unlock the cage assembly from the system.
Hold the release levers, and lift the cooling fan cage assembly away from the system.
Side wall brackets Left
Identify the side wall brackets highlighted in blue.
Press the tabs to release the side wall cable holder.
Move the cables out of the side wall cable holder and observe the cable routing.
Press the center tab to release the bracket from the chassis, and lift it away from the system.
Side wall brackets right
Identify the side wall brackets highlighted in blue.
Press the tabs to release the side wall cable holder.
Move the cables out of the side wall cable holder and observe the cable routing.
Press the center tab to release the bracket from the chassis, and lift it away from the system.
Install
Side wall brackets right
Identify the side wall brackets location highlighted in blue.
Align and slide until the side wall brackets is seated firmly.
Close the side wall cable holder until the holder clicks into place.
Side wall brackets Left
Identify the side wall brackets location highlighted in blue.
Align and slide until the side wall brackets is seated firmly.
Close the side wall cable holder until the holder clicks into place.
Cooling fan cage assembly
Identify the cooling fan cage assembly location highlighted in blue.
Align and place the cooling fan cage assembly into the system until seated firmly.
Rotate the blue release levers to lock the cooling fan cage assembly into the system.
Drive backplane cover
Identify the drive backplane cover location highlighted in blue.
Align and place the drive backplane cover on the system.
Slide the drive backplane cover to the front of the system until it fits into place.
Air shroud
Identify the air shroud location highlighted in blue.
Tilt at an angle and align the tabs with the slots on the system and place the air shroud until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a flat head or Phillips screwdriver, rotate the lock clockwise to the lock position.