Removal
Base Cover
Align the system with the outline to enable the AR lock.
Identify the base cover highlighted in blue.
Loosen the thumbscrew that secures the cover to the system.
Slide and lift the cover to remove from the system.
Hard Drive Module
Identify the hard drive assembly highlighted in blue.
Press the blue tabs on both sides of the hard drive assembly and slide to release it from the system.
Remove the hard drive assembly from the system.
VGA port
Identify the VGA port highlighted in blue.
Disconnect the cable from the connector on the system board.
Remove the screw that secure the VGA port to the system.
Remove the screws that secure the VGA port to the system.
Pull and lift the VGA port away from the system.
Install
VGA port
Identify the VGA port position highlighted in blue.
Insert and align the VGA port into the system.
Install the screw that seure the VGA port to the system.
Install the screws that seure the VGA port to the system.
Connect the cable to the connector on the system board.
Hard Drive Module
Identify the hard drive assembly location highlighted in blue.
Insert the drive assembly into the slot on the system.
Slide the drive assembly toward the connector until it clicks into place.
Base Cover
Identify the base cover location highlighted in blue.
Place the cover on the system and slide the cover until it clicks into place.
Tighten the thumb screw to secure the cover to the system.