Removal
Stand
Identify the stand highlighted in blue.
Press and hold down on the tab that secures the stand to the display assembly base.
Lift the stand off the display assembly base.
Identify the stand location highlighted in blue.
Align the stand to the slot with the display assembly base.
Slide the stand into place into the slot on the display assembly base.
Back Cover
Identify the back cover highlighted in blue.
Using your palm, gently pry the back cover from the top corners of the display assembly base.
Lift the back cover off the display assembly base.
Identify the back cover location highlighted in blue.
Align the slots on the back cover with the slots on the computer.
Slide to install back cover and press along the side to snap the back cover into place.
I/O Cover
Identify the I/O cover highlighted in blue.
Remove the screws that secure the I/O cover to the display assembly base.
Using a pry tool, pry open the corners and bottom of the I/O cover.
Pry open at the corner and lift the I/O cover off the display assembly base.
Identify the I/O cover location highlighted in blue.
Place the I/O cover on the display assembly base and align with screw holes.
Install the screws that secure the I/O cover to the display assembly base.
System Board Shield
Identify the system board shield highlighted in blue.
Remove the screws that secure the system board shield to the display assembly base.
Lift the system board shield off the display assembly base.
Identify the system board shield location highlighted in blue.
Place the system board shield on the display assembly base and align with screw holes.
Install the screws that secure the system board shield to the display assembly base.
Memory Module
Identify the memory module highlighted in blue.
Using your fingertips, carefully spread apart the securing clips on each end until the memory module pops up.
Hold the edges and carefully lift the memory module up from connector on the system board.
Identify the memory module location highlighted in blue.
Align the notch on the memory module with the tab on the slot and slide the memory module into the slot at an angle.
Press the memory module down until it clicks into place.
Install
Memory Module
Identify the heatsink location highlighted in blue.
Apply a pea sized amount of thermal material as shown.
Install the heatsink into the slot on the system board.
Tighten the captive screws that secure the heat sink. Tighten in order. Do not over tighten.
System Board Shield
Identify the heatsink location highlighted in blue.
Apply a pea sized amount of thermal material as shown.
Install the heatsink into the slot on the system board.
Tighten the captive screws that secure the heat sink. Tighten in order. Do not over tighten.
I/O Cover
Identify the heatsink location highlighted in blue.
Apply a pea sized amount of thermal material as shown.
Install the heatsink into the slot on the system board.
Tighten the captive screws that secure the heat sink. Tighten in order. Do not over tighten.
Back Cover
Identify the heatsink location highlighted in blue.
Apply a pea sized amount of thermal material as shown.
Install the heatsink into the slot on the system board.
Tighten the captive screws that secure the heat sink. Tighten in order. Do not over tighten.
Stand
Identify the heatsink location highlighted in blue.
Apply a pea sized amount of thermal material as shown.
Install the heatsink into the slot on the system board.
Tighten the captive screws that secure the heat sink. Tighten in order. Do not over tighten.