Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock counter clockwise.
Lift the latch till the system cover slides back.
Hold the cover on both sides, and lift the cover away from the system.
Air Shroud
Identify the air shroud highlighted in blue
Holding the blue touch points, apply firm pressure to remove the air shroud.
System Memory
Select the system memory you want to replace. System can have up to 24 dimms installed.
To release the memory module from the socket, simultaneously press the ejectors on both ends of the socket.
Holding the memory by the edges, lift to remove.
Install
System Memory
Confirm the highlighted memory dimm is the correct location to install or change selection.
Align the edge connector of memory module with the alignment key of the memory module socket, and insert into the socket.
Press the memory module until the socket levers firmly click into place.
Air Shroud
Identify the air shroud location highlighted in blue
Align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it clicks into place.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system.
Push the system cover latch down.
Using a 1/4" Flathead or a Phillips #2 screwdriver, rotate the lock clockwise.