Removal
Front Bezel
Identify the front bezel highlighted in blue.
Unlock the bezel.
Press the release button, and pull the left end of the front bezel.
Unhook the right end, and remove the bezel.
Drive carrier
Select the drive carrier, you want to replace.
Press the release button to open the drive carrier release handle.
Holding the drive carrier release handle, slide the drive carrier out of the drive slot.
System Cover
Identify the system cover highlighted in blue.
Using a 1/4 inch flat head or a phillips #2 screwdriver rotate the lock counterclockwise to the unlock position.
Lift the release latch until the system cover slides back.
Lift the cover from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the edges of the air shroud, and lift the air shroud out of the system.
Drive backplane cover
Identify the drive backplane cover highlighted in blue.
Slide the backplane cover in the direction of the arrows marked on the drive backplane cover.
Lift the backplane cover from the system.
Drive backplane
Identify the drive backplane highlighted in blue.
Loosen the screw on the cable guiding latch and lift the latch to remove the cables.
Open the latch to unroute the cable from the system.
Disconnect the drive backplane cable from the connector on the system board.
Press the blue release tabs to disengage the drive backplane from the hooks on the system.
Lift and pull the drive backplane out of the system.
Using a phillips #2 screwdriver, loosen the screws on the front PERC module.
Slide the front PERC module to disengage from the connector on the drive backplane. After performing the steps, the drive backplane remains.
Install
Drive backplane
Identify the drive backplane location highlighted in blue.
Slide the front PERC module until the module is connected to the drive backplane.
Using a phillips #2 screwdriver, tighten the screws on the front PERC module.
Use the guides on the system to align the slots on the backplane.
Insert the backplane into the guides and lower the backplane until the blue release tabs clicks into place.
Route the cables properly through the cable guide and close the latch to secure the cable.
Close the cable guiding latch and tighten the screw.
Connect the drive backplane cable to the connector on the system board.
Drive backplane cover
Identify the drive backplane cover location highlighted in blue.
Align the drive backplane cover with the guide slots on the system.
Slide the drive backplane cover to the front of the system until the drive backplane cover fits into place.
Air Shroud
Identify the air shroud location highlighted in blue.
Holding the edges of the air shroud, align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a 1/4 inch flat head or phillips #2 screwdriver, rotate the lock clockwise to the lock position.
Drive carrier
Confirm the drive carrier, you want to replace.
Press the release button on the front of the drive carrier to open the release handle.
Slide the drive carrier into the drive slot.
Close the drive carrier release handle to lock the drive in place.
Front Bezel
Identify the front bezel location highlighted in blue.
Align and insert the tabs on the bezel into the slots on the system.
Press the bezel until the release button clicks in place.
Lock the bezel.