Removal
System Cover
Identify the system cover highlighted in blue.
Using a 1/4 inch flat head or a phillips #2 screwdriver rotate the lock counterclockwise to the unlock position.
Lift the release latch until the system cover slides back.
Lift the cover from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the edges of the air shroud, and lift the air shroud out of the system.
Riser - 2A
Identify the riser highlighted in blue.
Press the blue button on the riser, and holding the touch points lift the expansion card riser from the riser connector on the system board.
Optional OCP card
Identify the optional OCP card highlighted in blue.
Open the blue latch to unlock the OCP card.
Push the OCP card towards the rear end of the system to disconnect from the connector on the system board.
Close the OCP card blue latch on the system board.
Install
Optional OCP card
Identify the optional OCP card location highlighted in blue.
Open the blue latch on the system board.
Slide the OCP card into the slot in the system.
Close the latch to lock the OCP card to the system.
Riser - 2A
Identify the riser location highlighted in blue.
Holding the edges or the touch points, align the holes on the expansion card riser with the guides on the system board.
Lower the expansion card riser into place and press the touch points until the expansion card riser connector is fully seated on the system board connector.
Air Shroud
Identify the air shroud location highlighted in blue.
Holding the edges of the air shroud, align the tabs on the air shroud with the slots on the system.
Lower the air shroud into the system until it is firmly seated.
System Cover
Identify the system cover location highlighted in blue.
Align the tabs on the system cover with the guide slots on the system and slide the system cover.
Close the system cover release latch.
Using a 1/4 inch flat head or phillips #2 screwdriver, rotate the lock clockwise to the lock position.