Removal
Front Top Cover
Identify the front top cover highlighted in blue.
Using a flathead or Phillips #2 screwdriver, rotate the lock counterclockwise.
Lift the latch until the front top cover slides back.
Hold the cover on both sides and lift it away from the system.
Rear Top cover
Identify the rear top cover highlighted in blue.
Lift the rear top cover from the system in the direction of the marked arrows.
Support Bracket
Identify the support bracket highlighted in blue.
Move the cables away from the support bracket.
Pull the plunger on either side of the installed support bracket to unlock it.
Lift the support bracket to remove it from the system.
Air Shroud
Identify the air shroud highlighted in blue.
Disconnect the cables from the power distribution board.
Unroute the cables from the air shroud.
Pinch and hold the air shroud from the middle and lift it from the system.
Cooling fan cage assembly
Identify the cooling fan cage assembly highlighted in blue.
Loosen the screw on the latch that secures the cables.
Open the latch that secures the cables.
Unroute the cables from the cooling fan cage.
Using a Phillips #2 screwdriver, loosen the screws to unlock the cooling fan cage assembly.
Lift the cooling fan cage assembly from the system.
GPU Fan Cage Assembly
Identify the GPU fan cage assembly highlighted in blue.
Loosen the screws that secure the GPU fan cage assembly.
Lift the GPU fan cage assembly from the system.
GPU Sled
Identify the GPU sled highlighted in blue.
Remove the screws on the side of the chassis to release the GPU sled.
Loosen the thumb screws that secure the GPU sled latch.
Rotate the handles and slowly pull the GPU sled toward the rear of the system.
Install the GPU sled handles to help slide out the remaining GPU sled.
Holding the GPU sled handles, slide the GPU sled out to remove it from the chassis.
Install
GPU Sled
Identify the GPU sled location highlighted in blue.
Press the release latches, then slide the GPU sled halfway into the chassis using the handles.
Remove the GPU sled handles by pulling the thumb screws and sliding them out.
Rotate the GPU sled handles inward to completely slide the GPU sled into the chassis.
Tighten the thumb screws that secure the GPU sled handles.
Install the screws on the side of the chassis to lock the GPU sled.
GPU Fan Cage Assembly
Identify the GPU fan cage assembly location highlighted in blue.
Align it with the screw holes and place the GPU fan cage assembly into the system.
Tighten the screws that secure the GPU fan cage assembly.
Cooling fan cage assembly
Identify the cooling fan cage assembly location highlighted in blue.
Align it with the screw holes and place the cooling fan cage assembly onto the system.
Using a Phillips #2 screwdriver, tighten the screws to lock the cooling fan cage assembly.
Route the cables through the cooling fan cage.
Close the latch that secures the cables.
Tighten the screw on the latch that secures the cables.
Air Shroud
Identify the air shroud location highlighted in blue.
Pinch and hold the air shroud from the middle, and place it onto the system.
Route the cables through the air shroud.
Connect the cables to the power distribution board.
Support Bracket
Identify the support bracket location highlighted in blue.
Align the bracket’s guide slots with the system guides, then press until the plungers click into place.
Place the cables on the support bracket.
Rear Top cover
Identify the rear top cover location highlighted in blue.
Align with the tabs, then slide the rear top cover forward until it fits into place.
Front Top Cover
Identify the front top cover location highlighted in blue.
Align the tabs on the front top cover with the guide slots on the system.
Push the front top cover latch down.
Using a 1/4-inch flathead or a Phillips #2 screwdriver, rotate the lock clockwise.