Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

BGP Configuration

To enable the BGP process and begin exchanging information, assign an AS number and use commands in ROUTER BGP mode to configure a BGP neighbor.

By default, BGP is disabled.

By default, the system compares the MED attribute on different paths from within the same AS (the bgp always-compare-med command is not enabled).

NOTE: In the Dell Networking OS, all newly configured neighbors and peer groups are disabled. To enable a neighbor or peer group, enter the neighbor { ip-address | peer-group-name} no shutdown command.

The following table displays the default values for BGP.

Table 1. BGP Default Values
Item	Default
BGP Neighbor Adjacency changes	All BGP neighbor changes are logged.
Fast External Fall over feature	Disabled
Graceful Restart feature	Disabled
Local preference	100
MED	0
Route Flap Damping Parameters	half-life = 15 minutes reuse = 750 suppress = 2000 max-suppress-time = 60 minutes
Distance	external distance = 20 internal distance = 200 local distance = 200
Timers	keepalive = 60 seconds holdtime = 180 seconds
Add-path	Disabled