Passer au contenu principal
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Créez et accédez à une liste de vos produits
  • Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Enabling PVST+ Extend System ID

In the following example, ports P1 and P2 are untagged members of different VLANs. These ports are untagged because the hub is VLAN unaware. There is no data loop in this scenario; however, you can employ PVST+ to avoid potential misconfigurations.

If you enable PVST+ on the Dell Networking switch in this network, P1 and P2 receive BPDUs from each other. Ordinarily, the Bridge ID in the frame matches the Root ID, a loop is detected, and the rules of convergence require that P2 move to blocking state because it has the lowest port ID.

To keep both ports in a Forwarding state, use extend system ID. Extend system ID augments the bridge ID with a VLAN ID to differentiate BPDUs on each VLAN so that PVST+ does not detect a loop and both ports can remain in a Forwarding state.

Figure 1. PVST+ with Extend System ID Illustration of PVST+ with Extend System ID
Augment the bridge ID with the VLAN ID. PROTOCOL PVST mode extend system-id

Example of Viewing the Extend System ID in a PVST+ Configuration

Dell(conf-pvst)#do show spanning-tree pvst vlan 5 brief
                                 
                                 VLAN 5
                                 Executing IEEE compatible Spanning Tree Protocol
                                 Root ID Priority 32773, Address 0001.e832.73f7
                                 Root Bridge hello time 2, max age 20, forward delay 15
                                 Bridge ID Priority 32773 (priority 32768 
                                 sys-id-ext 5), Address 0001.e832.73f7
                                 We are the root of Vlan 5
                                 Configured hello time 2, max age 20, forward delay 15
                              

Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\