Passer au contenu principal
Quitter

Bienvenue dans l’univers Dell

Mon compte
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Créez et accédez à une liste de vos produits
  • Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.
Se connecter Créer un compte Connexion au compte Premier Connexion au programme de partenariat
Nous contacter

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Private VLAN Configuration Example

The following example shows a private VLAN topology.

Figure 1. Sample Private VLAN Topology Illustration of a sample private VLAN topology.
The following configuration is based on the example diagram for the FN IOM switch:
  • TenGig 0/0 and TenGig 0/23 are configured as promiscuous ports, assigned to the primary VLAN, VLAN 4000.
  • TenGig 0/25 is configured as a PVLAN trunk port, also assigned to the primary VLAN 4000.
  • TenGig 0/24 and TenGig 0/47 are configured as host ports and assigned to the isolated VLAN, VLAN 4003.
  • TenGig 4/0 and TenGig 0/23 are configured as host ports and assigned to the community VLAN, VLAN 4001.
  • TenGig 4/24 and TenGig 4/47 are configured as host ports and assigned to community VLAN 4002.
The result is that:
  • The ports in community VLAN 4001 can communicate directly with each other and with promiscuous ports.
  • The ports in community VLAN 4002 can communicate directly with each other and with promiscuous ports.
  • The ports in isolated VLAN 4003 can only communicate with the promiscuous ports in the primary VLAN 4000.
  • All the ports in the secondary VLANs (both community and isolated VLANs) can only communicate with ports in the other secondary VLANs of that PVLAN over Layer 3, and only when the ip local-proxy-arp command is invoked in the primary VLAN.
  • NOTE: Even after you disable ip-local-proxy-arp ( no ip-local-proxy-arp ) in a secondary VLAN, Layer 3 communication may happen between some secondary VLAN hosts, until the ARP timeout happens on those secondary VLAN hosts.

Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\