How To Replace Hard Drive and Carrier for PowerEdge 14th Generation Racks

This video will demonstrate replacement procedure of Hard Drive & Carrier for PowerEdge 14th Generation Racks.

Removing the drive from the drive carrier:
Using a Phillips #1 screwdriver, remove the screws from the slide rails on the drive carrier.
NOTE: If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screw driver to remove the drive.
Lift the drive out of the drive carrier.

Installing a drive into the drive carrier:
Insert the drive into the drive carrier with the connector end of the drive towards the back of the carrier.
Align the screw holes on the drive with the screws holes on the drive carrier.
When aligned correctly, the back of the drive is flush with the back of the drive carrier.
Using a Phillips #1 screwdriver, secure the drive to the drive carrier with screws.
NOTE: If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to install the drive.