How to Replace Raid Card on a PowerEdge R320

This video will demonstrate the replacement procedure of a Raid Card for PowerEdge R320.

Removing The Integrated Storage Controller Card:
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
Open the system.
NOTE: It is recommended that you remove the expansion-card riser 2, before removing the storage controller card.
Push down the two release levers at the edge of the card to disengage the card from the connector.
Disengage the card from the storage-controller card holder on the system board.
Remove the card.

Installing The Integrated Storage Controller Card:
Align one end of the card with the card holder on the system board.
Lower the other end of the card into the storage-controller card holder on the system board.
Press the touch-points on the card and push the card down until it is fully seated. When the card is fully seated, the release levers snap over the edge of the card.
Close the system.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.