Follow safety instructions. Power off, disconnect, and remove the system cover. Uninstall drive backplane cover and air shroud. Remove and replace the right control panel, securing cables properly. Reassemble components in reverse order for a complete installation.
Prerequisites
Follow the safety guidelines listed in the Safety instructions.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet, and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.
Remove the drive backplane cover:
Slide the drive backplane cover in the direction of the arrows marked on the drive backplane cover.
Lift the drive backplane cover from the system.
Remove the air shroud:
Hold the air shroud at both ends and lift the air shroud out of the system.
Removing the right control panel:
Disconnect the control panel cable and the VGA cable from the system board connector and remove the cable from cable clip.
NOTE: Observe the routing of the cable as you remove it from the system.
Using the Phillips #1 screwdriver, remove the screws that secure the right control panel assembly.
Hold the right control panel assembly and remove the control panel along with the cable from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing the right control panel:
Route the control panel cable through the side wall of the system and slide the cable into the clip.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
Align and insert the right control panel in the slot on the system.
Connect the right control panel cable and the VGA cable to the connector on the system board.
Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel to the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Install the air shroud:
Align the slot on the air shroud with the standoff on the system.
Lower the air shroud into the system until it is firmly seated.
Install the drive backplane cover:
Align the drive backplane cover with the guide slots on the system.
Slide the drive backplane cover toward the front of the system until the drive backplane cover fits into place.
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
