Replacing the system battery
Prerequisites
NOTE There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions. See the safety instructions that came with your system for more information.
Follow the safety guidelines listed in the Safety instructions.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet, and disconnect the peripherals.
Remove the system cover.
To remove the battery:
Push the battery holder clip.
NOTE Ensure that you do not push the battery holder clip more than 3.2 millimeters, It may damage the battery holder.
Lift the battery away from the system.
To install a new system battery:
Push the battery lock slightly away.
NOTE Ensure that you do not push the battery holder more that 3.2 millimeters or you might risk damaging the part.
Hold the battery with the + sign facing the positive side of the battery connector on the system board.
Insert the battery into the battery socket.
Installing the system cover:
Align the tabs on the system cover with the corresponding slots on the system.
Press the system cover until it clicks into place.
Place the system upright on a flat, stable surface.
Reconnect the peripherals and connect the system to the electrical outlet.
Power on the attached peripherals and then power on the system.
