How to replace the BOSS carrier on a PowerEdge R6715

This video demonstrates the process of removing and installing the BOSS carrier on a PowerEdge R6715.

In this video, we show how to replace the BOSS Carrier in a PowerEdge R6715. Before working inside your system, read through and follow safety guidelines to protect your system for potential damage and ensure your personal safety. For more information about safety guidelines, see the service manual at Dell.com/Support. 

To remove the BOSS carrier, pull out on the latch and then pull straight out of the system. To remove the m.2 nvme ssd, loosen the two captive screws on the cover, then tilt the cover and remove it. Lift the SSD at an angle and remove it from the connector on the carrier. Note, when replacing the SSD, be sure to replace the existing thermal pads with new ones.

To install the m.2 NVME SSD, align it at an angle with a connector and slide it in. Place the cover on the carrier and tighten the two captive screws to secure it in place. To install the BOSS carrier, align it with the system, slide all the way in, then close the latch to lock it in place. For more information or support about the PowerEdge R6715, visit Dell.com/Support.