Connectrix: Een Cisco MDS-switch opnieuw opstarten
Summary: Een Cisco MDS-switch opnieuw opstarten.
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Instructions
Als u een Connectrix MDS serie switch opnieuw wilt opstarten, voert u de volgende opdrachten uit om op te slaan, te configureren en opnieuw te laden.
WAARSCHUWING: DIT IS EEN ONDERBREKENDE PROCEDURE! AL HET FC-VERKEER (FIBRE CHANNEL) WORDT OP DEZE SWITCH GEDROPT TERWIJL DE SWITCH OPNIEUW WORDT GELADEN!
WAARSCHUWING: DIT IS EEN ONDERBREKENDE PROCEDURE! AL HET FC-VERKEER (FIBRE CHANNEL) WORDT OP DEZE SWITCH GEDROPT TERWIJL DE SWITCH OPNIEUW WORDT GELADEN!
- Sla de configuratie op:
copy run start
- Wacht tot het opslaan van de configuratie is voltooid.
- Zodra het opslaan van de configuratie is voltooid, laadt u de switch opnieuw:
reload
Affected Products
Connectrix MDS-Series HardwareProducts
Connectrix MDS-Series Firmware, Connectrix MDS-Series Hardware, Connectrix MDS-Series SoftwareArticle Properties
Article Number: 000009881
Article Type: How To
Last Modified: 22 Sep 2022
Version: 3
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.