Passer au contenu principal
Quitter

Bienvenue chez Dell

Mon compte
  • Passer des commandes rapidement et facilement
  • Voir les commandes et de suivre l'état de votre expédition
  • Profitez membres seulement récompenses et des remises
  • Créez et accédez à une liste de vos produits
  • Gérez vos sites Dell EMC, vos produits et vos personnes-ressources pour les produits dans Administration de l’entreprise.
Connexion Créer un compte Connexion Premier Connexion au programme Partner
Nous contacter

Vos paniers Dell.com

XPS 13 Service Manual

PDF

Procedure

  1. Disconnect the touchscreen cable (optional) and camera cable from the system board.
  2. Peel off the tape that secures the antenna cables to the system board.
  3. Remove the screw (M2x3) that secures the wireless-card bracket to the system board.
  4. Lift the wireless-card bracket off the wireless card.
  5. Disconnect the antenna cables from the wireless card.
    Figure 1. Removing the display assemblyImage: Disconnecting the touchscreen cable (optional), camera cable and antenna cable.
    1. touchscreen cable (optional)
    2. camera cable
    3. wireless-card bracket
    4. screw
    5. antenna cables (2)
    6. wireless card
    7. tape
  6. Remove the screw (M1.6x3) that secures the display cable to the I/O board.
  7. Peel off the tapes that secure the display cable to the fan and the I/O board.
  8. Disconnect the media-card reader cable from the I/O board.
  9. Note the display-cable routing and remove the cable from the routing guides on the fan.
  10. Peel off the tape from the display-cable bracket.
    Figure 2. Removing the display assemblyImage: Removing the tapes and disconnecting the display cable.
    1. tapes (4)
    2. screw
    3. media-card reader cable
    4. display cable
    5. routing guides (2)
  11. Remove the two screws (M2x3) that secure the display-cable bracket to the system board.
  12. Lift the display-cable bracket off the display cable.
  13. Using the pull tab, disconnect the display cable from the system board.
    Figure 3. Removing the display assemblyImage: Removing the tapes and disconnecting the media-card reader power cable.
    1. display cable
    2. display-cable bracket
    3. screws (2)
    4. pull tab
  14. Open the palm-rest assembly at an angle of 90 degrees, and then remove the four screws (M2.5x4) that secure the display hinges to the palm-rest assembly.
    Figure 4. Removing the display assemblyImage: Removing the screws from the palm-rest assembly.
    1. palm-rest assembly
    2. display assembly
    3. display hinges (2)
    4. screws (4)
  15. Slide and remove the palm-rest assembly from the display hinges.
    Figure 5. Removing the display assemblyImage: Removing the palm-rest assembly.
    1. palm-rest assembly
    2. display assembly
  Veuillez évaluer cet article (1 à 5 étoiles).
  Veuillez évaluer cet article (1 à 5 étoiles).
  Veuillez évaluer cet article (1 à 5 étoiles).
  Avez-vous trouvé cet article utile?
  Les commentaires ne peuvent pas contenir ces caractères spéciaux : <>()\