Přeskočit na hlavní obsah
Odhlásit

Vítejte ve společnosti Dell.

Můj účet
  • Vkládejte objednávky snadno a rychle
  • Zobrazit objednávky a sledovat stav expedice
  • Vytvořte a přistupujte k seznamu svých produktů
  • Spravujte své profily, produkty a kontakty na úrovni produktů na stránkách Dell EMC pomocí správy společnosti.
Přihlásit se Vytvořte si účet Přihlášení na stránky Premier Přihlášení do partnerského programu
Spojte se s námi

Dell PowerEdge R730 Owner's Manual

PDF

Installing an expansion card into the expansion card riser 2 or 3

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Unpack the expansion card and prepare it for installation.
    For instructions, see the documentation accompanying the card.
  2. Lift the expansion card latch and remove the filler bracket.
  3. Holding the card by its edges, position the card so that the connector on the expansion card aligns with the expansion card connector on the riser.
  4. Insert the card-edge connector firmly into the expansion card connector until the card is fully seated.
  5. Press the touch points to open the expansion card locking tabs.
  6. Close the expansion card latch.
    Figure 1. Installing an expansion card into the expansion card riser 2 or 3
    This figure shows installing an expansion card into the expansion card riser 2 or 3
    1. expansion card
    2. expansion card latch
    3. expansion card riser
    4. power connector (for GPU cards)
    5. expansion card connector
  7. If applicable, connect the cables to the expansion card.
    NOTE: When installing a GPU card on riser 2 or riser 3 (default), connect the GPU card power cable to the power connector on the riser.

Next steps

  1. Follow the procedure listed in the After working inside your system section.
  2. Install any device drivers required for the card as described in the documentation for the card.

Hodnoťte tento obsah

Přesné
Užitečné
Snadno srozumitelné
Byl tento článek užitečný?
0/3000 characters
  Zadejte hodnocení (1 až 5 hvězdiček).
  Zadejte hodnocení (1 až 5 hvězdiček).
  Zadejte hodnocení (1 až 5 hvězdiček).
  Vyberte, zda vám článek pomohl či nikoli.
  Komentáře nesmí obsahovat tyto speciální znaky: <>() \