Přeskočit na hlavní obsah
Odhlásit

Vítejte ve společnosti Dell.

Můj účet
  • Vkládejte objednávky snadno a rychle
  • Zobrazit objednávky a sledovat stav expedice
  • Vytvořte a přistupujte k seznamu svých produktů
  • Spravujte své profily, produkty a kontakty na úrovni produktů na stránkách Dell EMC pomocí správy společnosti.
Přihlásit se Vytvořte si účet Přihlášení na stránky Premier Přihlášení do partnerského programu
Spojte se s námi

Dell PowerEdge R730 Owner's Manual

PDF

Replacing the system battery

Prerequisites

NOTE: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your system.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Remove the cooling shroud.

Steps

  1. Locate the battery socket. For more information, see the Jumpers and connectors section.
    CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing or removing a battery.
  2. Place your finger between the securing tabs at the negative side of the battery connector, and lift the battery out of the socket.
    Figure 1. Removing the system battery
    This figure shows removing the system battery.
    1. system battery
    2. system battery slot
  3. To install a new system battery, hold the battery with the "+" facing up and slide it under the securing tabs.
  4. Press the battery into the connector until it snaps into place.
    Figure 2. Installing the system battery
    This figure shows installing the system battery.
    1. system battery
    2. system battery slot

Next steps

  1. Install the cooling shroud.
  2. Follow the procedure listed in the After working inside your system section.
  3. While booting, press F2 to enter System Setup and ensure the battery is operating properly.
  4. Enter the correct time and date in the System Setup Time and Date fields.
  5. Exit System Setup.

Hodnoťte tento obsah

Přesné
Užitečné
Snadno srozumitelné
Byl tento článek užitečný?
0/3000 characters
  Zadejte hodnocení (1 až 5 hvězdiček).
  Zadejte hodnocení (1 až 5 hvězdiček).
  Zadejte hodnocení (1 až 5 hvězdiček).
  Vyberte, zda vám článek pomohl či nikoli.
  Komentáře nesmí obsahovat tyto speciální znaky: <>() \