Gå til hovedindhold
Log af

Velkommen hos Dell

Min konto
  • Afgiv ordrer hurtigt og nemt
  • Se ordrer og spor status for din forsendelse
  • Opret og få adgang til en liste med dine produkter
  • Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Log på Opret en konto Log på Premier Log på Partnerprogram
Kontakt os

Dine Dell.com-kurve

Dell PowerEdge R730 Owner's Manual

PDF

Installing a hot swappable hard drive or solid state drive

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
CAUTION: Use only hard drives that have been tested and approved for use with the hard drive backplane.
CAUTION: When installing a hard drive, ensure that the adjacent drives are fully installed. Inserting a hard drive carrier and attempting to lock its handle next to a partially installed carrier can damage the partially installed carrier's shield spring and make it unusable.
CAUTION: Combining SAS and SATA hard drives in the same RAID volume is not supported.
CAUTION: To prevent data loss, ensure that your operating system supports hot-swap drive installation. See the documentation supplied with your operating system.
CAUTION: When a replacement hot swappable drive is installed and the system is powered on, the drive automatically begins to rebuild. Ensure that the replacement drive is blank or contains data that you wish to overwrite. Any data on the replacement drive is immediately lost after the drive is installed.

Steps

  1. If a hard drive blank is installed in the hard drive slot, remove it.
  2. Install a hard drive in the hard drive carrier.
  3. Press the release button on the front of the hard drive carrier and open the hard drive carrier handle.
  4. Insert the hard drive carrier into the hard drive slot until the carrier connects with the backplane.
  5. Close the hard drive carrier handle to lock the hard drive in place.
    Figure 1. Installing a hot-swappable hard drive or SSD
    This figure shows installing a hot-swappable hard drive or SSD.
    1. release button
    2. hard drive or SSD carrier
    3. hard drive or SSD carrier handle
    Figure 2. Installing a 1.8 inch hot-swappable uSATA SSD carrier
    This figure shows installing a 1.8 inch hot-swappable uSATA SSD carrier.
    1. release button
    2. SSD carrier
    3. SSD carrier handle

Bedøm indholdet

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
0/3000 characters
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv, om artiklen var nyttig eller ej.
  Kommentarer må ikke indeholde følgende specialtegn: <>()\