Dell PowerEdge R730 Owner's Manual

Removing the cable retention bracket

Prerequisites

Follow the safety guidelines listed in the Safety instructions section.
Follow the procedure listed in the Before working inside your system section.
If installed, remove the cooling shroud.
Remove the PCIe card holder.
Remove all cables routed through the cable retention bracket.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

Pull the tab to release it from the notch and slide the cable retention bracket toward the front of the chassis to release it from the chassis.
Lift the cable retention bracket out of the chassis.
Figure 1. Removing the cable retention bracket
1. alignment pin (2)
2. tab
3. cable retention bracket

Next steps

Install the cable retention bracket and reconnect all cables routed through the cable retention bracket.
If removed, install the PCIe card holder.
If removed, install the cooling shroud.
Follow the procedure listed in the After working inside your system section.

Velkommen

Velkommen hos Dell

Dell PowerEdge R730 Owner's Manual

Removing the cable retention bracket

Prerequisites

Steps

Next steps

Bedøm indholdet