Gå til hovedindhold
Log af

Velkommen hos Dell

Min konto
  • Afgiv ordrer hurtigt og nemt
  • Se ordrer og spor status for din forsendelse
  • Opret og få adgang til en liste med dine produkter
  • Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Log på Opret en konto Log på Premier Log på Partnerprogram
Kontakt os

Dine Dell.com-kurve

Dell PowerEdge R730 Owner's Manual

PDF

Removing an expansion card from expansion card riser 2 or 3

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. When removing a card from riser 3, ensure that the PCIe holder latch is closed.
NOTE: The procedure for installing and removing a full length PCIe card is similar to the procedure for removing and installing a GPU card.

Steps

  1. Disconnect any cables connected to the expansion card.
  2. Lift the expansion card latch out of the guide slot.
  3. Hold the expansion card by its edges, and remove it from the expansion card connector.
  4. If you are removing the card permanently, install a metal filler bracket over the empty expansion slot opening and close the expansion card latch.
    NOTE: You must install a filler bracket over an empty expansion card slot to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. The filler bracket is necessary to maintain proper thermal conditions.
  5. Install the expansion card latch into the slot.
  6. Close the expansion card locking tabs.
    Figure 1. Removing an expansion card from expansion card riser 2 or 3
    This figure shows removing an expansion card from an expansion card riser 2 or 3.
    1. expansion card
    2. expansion card latch
    3. expansion card riser
    4. power connector (for GPU cards)
    5. expansion card connector

Next steps

  1. Install an expansion card into the expansion card riser.
  2. Follow the procedure listed in the After working inside your system section.

Bedøm indholdet

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
0/3000 characters
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv, om artiklen var nyttig eller ej.
  Kommentarer må ikke indeholde følgende specialtegn: <>()\